80-0067-00-MO-RevF 2017-10-03 SunTech CT40 User Manual | 23
The timer will then count down the
seconds until the first reading.
After all measurements are taken
and averaged, results will display.
A long beep will sound to indicate
measurement is complete.
Example of SYS, DIA and HR* after
BP measurement in Single
Measurement Mode.
Example of SYS, DIA and HR* after
all measurements have been
averaged.
Example of SphygMode display with
cuff pressure at zero. P-set value is
default 160 mmHg.
*Note: Pulse rate source, whether BP or SpO
2
, can be selected at any time using the Advanced Configuration
Application. The default setting uses BP as HR source. If used outside of the United States, the device also can be
configured to measure MAP using the Configuration Application. If set up to measure MAP, the MAP and HR
measurements will alternate in 3-second intervals.
NOTE: MAP is not available in the U.S.
Step 5: Record Results
When the measurement cycle is complete, values will be displayed for systolic and diastolic pressure, plus heart rate
if BP is selected as the pulse rate source.* Manually record, print and/or digitally save your measurements according
to your healthcare facility’s preferred process. To send results to an EMR or to the device memor
y, follow the steps in
Section 4.
Step 6: Prepare for New Patient
After all measurements have been recorded or captured, remove the cuff from the patient and clean it according to
your facility’s requirements. This disinfecting and storage step applies to
BP cuffs as well as other optional
accessories whose use will be covered in the following sections.
Pressing the Memory Button
will clear all patient and measurement data from the display, in addition to
saving the patient and measurement information in memory. It is recommended that the display is cleared before
taking readings on a new patient.
