- Please press the POWER button again to turn off the unit.
2.
Functions
- The device has three functions: Cooling, ventilation and dehumidification. For night operation, we
recommend that you operate the unit in sleep mode.
Attention:
This mode can only be selected via the remote control.
2.1 Cooling Mode
- Please select the cooling mode to lower the temperature in your room
- Please press the MODE button repeatedly until the "Cool" indicator lights up.
- Press the up/down button to set the temperature. The temperature can be set between 16
℃
and
32
℃
.
- Please press the fan speed button repeatedly until the desired indicator lights up.
To control the direction of airflow horizontally, manually adjust the blades on the air outlet.
The air conditioner stops when the room temperature is below the set temperature.
2.2 Fan Mode
- Drücken Sie bitte die MODE-Taste wiederholt, bis der „Fan“ -Indikator aufleuchtet.
Im Ventilationsmodus wird die Raumluft umgewälzt, aber nicht gekühlt.
- Bitte drücken Sie die SPEED-Taste, um die hohe oder niedrige Geschwindigkeit auszuwählen.
2.3 Dehumidification Mode
- Press the MODE button on the control panel or remote control until the "Dry" indicator lights up. The
fan speed cannot be selected. The user should connect the drainage hose to the drain at the bottom
of the unit.
Note
: In this mode, the fan speed switches to Low and cannot be set.
2.4 Sleep Mode
（
can only be set via remote control
）
The cooling mode can be activated in sleep mode.
-In Cooling Mode:
After 1 hour the preset temperature is automatically increased by 1
℃
, after another hour the preset
temperature is automatically increased again by 1
℃
.
3.
TIMER 1h-24h:
When the unit is switched on, press the TIMER button first. Now you can set the desired switch-off time
with the up/down buttons.
When the unit is switched off, press the TIMER key to set the switch-on time.
Deactivate Timer
: Press the Up/Down button repeatedly until '00' appears on the display.
Note
: If you press the POWER button during this time, the timer function will be deactivated.
4.
Automatic Frost Protection:
At low room temperatures, frost may accumulate on the evaporator during operation. In this case,
the unit automatically starts defrosting and the POWER LED flashes. The defrost control sequence
is as follows:
-
When the unit is operating in cooling mode or dehumidification mode, the ambient temperature
sensor detects the evaporator coil temperature. As soon as this drops below -1°C, the compressor
is switched off. After the compressor has stopped operating for 10 minutes or reaches the coil
temperature 7
℃
, the unit restarts in cooling mode.
5.
Overload Protection:
In the event of a power failure, there is a 3-minute delay until the compressor restarts to protect the
compressor.
Emptying of the water tank
Please switch off the appliance before emptying the water tank.
Remove the plug from the water outlet and keep it in a safe area. Please connect the drain hose securely and
properly and ensure that it is not kinked and free of obstacles. Please place the hose outlet over a drain or
bucket and make sure that the water can escape freely from the unit. Please do not immerse the end of the
hose in water, as this may result in an "air lock" in the hose.
To avoid water leakage:
Since the negative pressure of the condensate tray is high, please tilt the drain hose downwards to the floor. It
is advisable that the inclination exceeds 20 degrees.
