Form 44201440
15
Oct 2018
e)
Hanging points are a fixed length between centers. Secondary steel work may be required to span between
supporting beams.
f)
The appliance should be located with respect to building construction and other equipment to permit access
to the appliance for servicing etc.
f)
The heater must be installed in an adequate free area to allow the products of combustion to freely escape
from the heater. The heater must not be installed in recessed spaces or enclosure and alcoves.
g)
The heater must be suspended with its longitudinal axis horizontal, but may have its lateral axis at an angle
from 0
0
to 60
0
from the horizontal, as shown in the minimum clearances to combustibles section 4.0).
h)
An optional heat shield may be installed to reduce the top distance of clearance to combustibles. This heat
shield should be installed prior to hanging the heater. When using the heat shield at the minimum clearance
distance the angles of installation are restricted to 0, 15, 30, 45 and 60°.
i)
Use the provided angle gauge to ensure that the heater is hung at the approved installation angles.
j)
The heater can be angle mounted on both sides of its lateral axis.
k)
Hanging brackets should first be fixed to the wall surface by means of 4 lag bolts
–
not supplied (3/8” x 1
-
1/2”
minimum) through pre-formed holes in each of the brackets prior to installing heater.
HEATER MOUNTING ANGLE
Every heater is supplied with an angle gauge. The gauge is attached with tape to the heater control side.
The angle gauge is used in combination with a level to ensure that the heater is installed at one of the mounting
angles of 0
0
, 15
0
, 30
0
, 45
0
and 60
0
.
Summary of Contents for SGL35-L7
Page 36: ...Form 44201440 35 Oct 2018 ...
Page 45: ......
