13
②
③
⑤
④
10mm
①
Replacing Parts
1) Replacing Knife Sharpening Stone
(1) Carefully observe how the flat belt is mounted before removing it.
(2) As in Figure 14, hold sharpening stone
①
with your left hand and pulley
③
with your right hand. Turn your right hand
counterclockwise to separate the pulley from the stone.
(3) Insert the stone knot spanner
④
, as in Figure 15, in the knot’s holes
⑤
. Turn it counterclockwise to separate it from the
stone (Figure 15).
(4) When remounting the flat belt, as in Figure 16, remount it so that the stone rotates clockwise when seen from the top of
the machine.
7
[Figure 14]
[Figure 15]
[Figure 16]
②
⑤
④
③
①
2) Replacing feeding roller
(1) Relocate the spring lever
①
to the bed’s lever peg
②
.
(2) Hold the support arm
③
with your left hand and loosen
the center pin fixation screw
④
. Pull the center pin
⑤
to
remove the support arm
③
.
Note) Be careful when you are replacing the feeding
roller, since the knife may come into contact with
other objects, forcing the blade to lose its sharp
edge. Take special note of the fact that the joint
which rotates the feeding roller is separately
assembled and may easily come into contact with
the knife as you try to remove it. To avoid this
from happening, support the joint with your hand
as you remove it.
(3) Loosen the screw
②
of the roller base
①
and remove the
roller shaft
③
which will allow you to separate the roller
④
.
(4) Remove the feeding roller support arm
③
, as in Figure 17.
[Figure 17]
Note) If you have separated the stone from the knot to replace a new one, be sure to install the stone and the knife so that
they are 10mm apart, as in Figure 16.
Note) Be careful not to leave oil stains on the stone.
②
④
③
①
[Figure 18]
