Sunrise MORTAR GUN 3000, Operator'S Manual

Page: 8 / 16

We recommend removing the
chuck from the drill and threading
the Cam-Coupling on to the drill
mandrell. This makes the whole
assembly shorter with much better
balance.
If this is the method you
choose, please see picture #1.
Some drills have a left threaded Reversing-Screw
holding the chuck onto the drill. Open the Chuck
all the way. Then look inside the chuck to see what
style of screw head is used (Allen head, Phillips,
Straight ,etc....) This screw is removed by turning the
screw clockwise while holding the chuck from
turning with the chuck key in place as in picture #1.
Once the Reversing-Screw is removed hit the back
end of the Chuck-Key with a hammer as shown and
the Chuck will unscrew.
1.
If you do not remove the Chuck from your
drill simply chuck the 3/8th inch
CAM-Stud (#704) into the chuck as shown .
2.
To connect the drill to the
Quikpoint assembly simply
put the drill in forward and
screw the drill arbor or the
cam stud into the back of the
Cam-Coupling see fig#3 &#4
3.
4.
5.
Slip the Ring-Clamp
(#711)over the drill and
Drill Mount Arms.
Secure Ring-Clamp
in suitable place on
drill . Avoid covering
air vents.
6.
7.
If needed, the Drill Mount Arms (#710) can
be extended back by mounting the
arms as shown with two bolts
Mounting a Drill
Drill with chuck
removed
Drill with chuck and
male Cam-Stud
6.
(#710)
To install Cam-Guard (#909)
after drill is mounted push
up under and between Drill
Mount Arms then snap over
hopper tongue.