Sunrise telecom XTT 5000, User Manual

Page: 33 / 181

XTT 5000 System
Network Setup Home
Configure system settings if necessary. Access this window from the System menu
Network Setup tab.
Ethernet Port
Configure the system settings, if necessary.
IMPORTANT NOTE : These settings apply to the XTT 5000 module’s own LAN
port, NOT the test ports. Changing these settings may cause the module to lose
connection with the system.
Parameter Details
Admin IP Enter the IP address for the XTT 5000 module.
Subnet Mask Enter the subnet address for the XTT 5000 module, if
appropriate.
Gateway Specify the gateway address for the XTT 5000. Used for
static IP.
DHCP Enabled XTT 5000 automatically retrieves the appropriate IP
address when connected to a LAN. When enabled, the
previous three items are grayed out.
MAC Address View the LAN port's MAC address.
DNS servers
Parameter Details
Primary DNS
Server Specify the local primary (master) DNS server address.
Enter an address directly, using the number pad which pops
up.
The secondary Server is a server that obtains information
about a zone from a Primary Server via a zone transfer
mechanism. Sometimes known as a Slave Server.
Secondary DNS
Server
Specify the secondary (slave) DNS server address.
Where do you want to go next?
Configure an RJ-45 port.
Configure an SFP port.
Meas. Setup : Configure measurement parameters
Throughput Test Setup
RFC2544/NE Applications
IP Test Setup
Monitor Setup
Loopback Test Setup
Home
27