24
EN
GLISH
Elite
2
Mini XS Plus Rev.B
KM/H
A. LCD Display
The backlit LCD display can display:
• Speed in Kilometres per hour (km/h) or Miles per hour (m/h).
• Total distance in Kilometres (km) or Miles (m),
• Trip distance – reset by holding down MODE button, 7.1.7, (Fig.7.1).
• Total Hours the scooter has been used (h).
• Fault display – see troubleshooting section.
B. Directional Arrow
When used with an optional foot or twist grip hand control the flashing arrow indicates travel in reverse
direction, (Fig 7.1-Label 7.1.10A), (also see section 7.13).
C. Battery gauge
This indicates the average amount of charge you have in the batteries. Please be aware that the meter
reading may fluctuate when the scooter is in use, this is normal.
Fig 6.1: Green indicates fully charged batteries with reducing charge to the red indicator. Red indicates
warning and less than half-charged batteries.
Fig 6.2: 10 bars indicates fully charged batteries this is shown by the full battery symbol. 50% charge is
approximately 5 bars. The battery gauge will flash when the batteries are in a very low state of charge. It
is recommend that, if possible, you charge the scooter when the gauge displays 2 bars.
D. Speed control
This allows you to preset your desired scooter speed.
Turn the dial anti-clockwise to slow for very gentle operation. Turn it clockwise to increase your speed to
maximum
Remember that only with practice will you become a competent driver. Find a safe, hazard free
environment to practice controlling the scooter and familiarise yourself with the controls and functions.
E. Lights
Pressing the button will turn on the front LED headlight, and the rear LED lights
NOTE:
If the lights are inadvertently left on after use, removing the ON/OFF key will extinguish the lights
automatically.
F. Indicators
Pressing the button will illuminate the front and rear LED indicators in a flashing pattern indicating you
are turning the scooter. On the keypad the visual indicator light will also flash, and the scooter will emit
a beeping tone.
To turn off the indicators press the button again. Alternatively, the direction indicators will automatically
turn off after a distance of approximately 30 meters.
G. Hazard lights
With the scooter ON the front and rear LED indicators will flash simultaneously when this button is
pressed.
The visual indicators on the direction buttons on the keypads will also illuminate.
Press the button again to switch the hazard lights off.
H. Horn
The horn will sound while this button is depressed.
I. Control levers
(See 6.1.2).
(L)
J. Mode button
Pressing the Mode button will change the information shown in the LCD display 7.1.10
• Pressing and HOLDING the Mode button will reset the trip distance displayed.
• Press once to show total distance travelled.
• Press twice to show total trip distance travelled (LCD will display a “t”).
• Press a third time to show total hours of use.
• Press fourth time to return to speed display.
(R)
K. Time/Temp Button
Each press of this button will change the display to show either the time or the current ambient
temperature.
NOTE:
The ambient temperature display is an indication only of current ambient temperature. Due to
the numerous factors that affect temperature sensing, the displayed temperature should only be taken
as a guide.
6.1 Definitions
