Watch our installation video at Electric-Bike-Kit.com/install
FOR LONG-TERM BATTERY STORAGE, CHARGE BATTERY TO FULL MONTHLY
1) Plug battery into charger and then plug charger into wall socket.
2)
Turn battery switch ON (red plastic showing on switch).
3) When charge is complete, turn OFF the battery switch, and disconnect all plugs.
Charger light indicator colors for 36v Ranger battery:
Red: Charging
Solid Green: Fully charged/Standby
*Note: Charger may become warm to the touch during charging. This is typical. It is
recommended that you keep it out of direct contact with combustible materials.
Helpful tip
: For longest battery life, top off the battery to 100% after each ride. Once fully
charged, unplug from the charger. Do not leave on charger for more than 12 hours.
- My forks contact the motor:
Insert no more than one additional thin washer between the
motor and tab washer (see the axle hardware diagram on the next page). Ensure that the tab
washers still lock into place on the axle.
- My fork
“dropout notches” are too small for the motor axle:
File the dropout notch on your
forks by 0.5mm.
- Battery not charging:
Turn battery switch
ON
to charge.
- Motor is making a
“Clunk... clunk... clunk” sound, turns very slowly, or is not turning
on:
Repeat battery charging instructions. If problem persists,
please contact our Technical
Support team at
(206) 682-7520
from 9am to 3pm PST Monday-Friday, or
We will repair or replace any defective components under warranty at no additional cost.
V.1.4
Ranger 36 Volt/350 Watt
stallati a d Operati g I structi
BATTERY CHARGING
1. Remove handlebar grip.
-Some grips have locking bolts
on the end of the handlebar.
-If resistance is too great, you
can heat the grip with a hair-
dryer.
-Grips may be cut off of the bar,
but will need to be replaced.
2. Loosen brake/shifter and
slide off of handlebar.
-Usually there is only one bolt
located on the backside or
underside of the handlebar.
-Cables do not need to be
disengaged to remove the
brake lever.
3. Slide throttle on before
replacing brake lever.
-Make sure that the
throttle lever is in your
preferred orientation.
-Tighten the bolt on the
underside of the throttle
with a 3mm hex wrench.
4. Replace brake lever and
handlebar grip.
-Tighten down the brake lever
in its original position.
-Slide grip back into place.
-If resistance is substantial,
heating the grip with a hair
dryer can ease installation.
Pull off
Brake lever
bolt
Throttle
bolt
Push on
T OU
S OOT G (Mor fo at th Electric-Bike-Kit.com fo Page)