-Steel bicycle fork is recommended with hub-
motor.
-Remove your front wheel, set Hill Topper
motorized wheel in its place.
-From riding position, the motor cable should
emerge from the RIGHT side of the motor (the
same side as your chain).
-Ensure that the axle hardware is in the correct
order.
-Make sure that the wheel can turn without
rubbing or grinding on the forks or brakes.
-Additional washers may be used if necessary to
accommodate your specific fork shape and size.
-Use a wrench to tighten bolts to 28 foot-pounds.
-Make sure your tire is inflated and your brakes
are adjusted, and you’re ready to go!
Proper hardware order
Axle 1 2 3 4 5
The “tab” on
washer #2 faces
out from the
motor, and down
toward the motor
cable.
IMPORTANT:
Incorrect tab
washer installation
can cause serious
damage to the
motor cable!
Thin Tab Thick Wide Axle
Washer Washer Washer Washer Nut
Insert
Fork
The motor cable will emerge from just below the end of
the fork (which is called the “dropout”), when installed
correctly. If installed incorrectly, it could interfere with
your spokes or damage your cable. Before you ride or
run your kit, double-check that the cable is in the
correct orientation.