2 Issue 4
22
2
1
4
Fig. 24
Chair features
Swing-away armrests
Swing-away, removeable armrests
(Fig. 23) are installed by sliding the
armrest tube (1) into the receiver
(2) on the rear frame tube, aligning
the slot on the end of the tube with
the screw (3). To remove the
armrest simply pull upwards until
the tube clears the receiver.
To rotate the armrest pull upwards for
approximately 25mm (1") and rotate
away from the chair.
1
2
Fig. 23
Quick-release axles
To remove quick-release axles
(Fig. 24) simply press the quick
release button (1) which is located
in the wheel hub (2), and grip the
wheel through the spokes (3)
around the hub and pull the axle
out of its sleeve (4). To replace,
slide the axle into the sleeve until
the release button ‘pops’ out and
the two locking pins (5) are visible
on the inside (6) of the sleeve.
Warning:
The axle is not secure until the
outside quick-release button pops
out to its fully extended position, and
the locking pins (5) on the inside of
the axle are in the locked position.
3
3
5
6
