Sunny Health & Fitness SF-S1403, Manual

Page: 8 / 10

METER INSTRUCTION
KEY FUNCTIONS:
MODE: Press the “RED” mode button to select
function.
(Time, Rep/Min, Count, Calorie and Scan).
OPERATION PROCEDURES:
1. AUTO ON/OFF:
If the steps of the machine are put into motion, or the mode button is pressed the computer
will become active, and shall remain active while either of these two things continue to be
done, however without any signal for approximately 4 minutes, power (computer), will turn off
automatically.
2. RESET:
The computer can be reset by pressing and holding the mode button for three seconds,
removing the batteries will also reset the computer and return all function settings back to
zero.
3. MODE:
To select the LOCK MODE setting press the MODE key when the pointer on the function you
wish to select begins to blink, (once locked only the selected function will be displayed).
4. FUNCTIONS:
TIME: Counts the total time of an exercise from start to finish.
CALORIES: Counts the amount of total calories burned during an exercise from start to finish.
COUNT: Automatically accumulates the count of steps made during exercise sessions.
REPS/MIN
:
Automatically displays the count of steps per minute.
SCAN : Press the MODE button to until the indicator arrow points to SCAN once on SCAN
the indicator arrow will continue to flash indicating that SCAN mode is active, afterwards it will
automatically scan through each function in sequence.
Note:
1. If you have an inaccurate reading on the monitor, please replace the battery immediately.
(See instructions below)
2. Please use (1) LR44, 1.5V battery.
3. The monitor is auto-powered. It turns on when exercise begins, and it turns off when no
movement is made between 4 to 5minutes.
4. All functions will automatically stop calculating when
STOP appears in the upper left corner
of the display monitor. This occurs when there is no signal for a period of 4 seconds. Once the
exercise begins again, the meter will automatically start recalculating and the
STOP will
disappear.
7