Pitched Roof Mount System
With Self-grounding Hardware
Pitched Roof Mount System
3
of
24
Installer Responsibility
Before ordering and installing materials, all system layout dimensions should be confirmed by field
measurements. SunModo reserves the right to alter, without notice, any details, proposals or plans.
Any inquiries that you may have concerning installation of the PV system should be directed to your
SunModo Sales representative. Consult SunModo Sales for any information not contained in this
manual. This manual is intended to be used as a guide when installing SunModo Pitch Roof PV
systems. It is the responsibility of the installer to ensure the safe installation of this product as outline
herein.
This racking system may be used to ground and/or mount a PV module complying with UL
1703 only when the specific module has been evaluated for grounding and /or mounting in
compliance with the included instructions.
The installer shall employ only SunModo products detail herein. The use of non SunModo
components can void the warranty and cancel the letters of UL compliance.
Guarantee that screws and anchors have adequate pullout strength and shear capacities.
Adhere to all relevant local or national building codes. This takes account of those that supplant
this document’s requirements.
Guaranteeing safe placement of all electrical details of the PV array
Installer is responsible to install EZ Roof Mount System over a Fire Resistant roof covering
rated for the application.
Installer is responsible to determine that the roof, its rafters, connections, and other
architectural support components can sustain the array under all code level loading conditions
The installer shall comply with all applicable local or national building codes, including periodic
re-inspection of the installation for loose components, loose fasteners and any corrosion, such
that if found, the affected components are to be immediately replaced.
This racking system may be used to ground and/or mount a PV module complying with UL
1703 only when the specific module has been evaluated for grounding and/or mounting in
compliance with the included instructions.
Safety
Review relevant OSHA and other safety standards before following these instructions. The installation
of solar PV systems is a dangerous procedure and should be supervised by trained and experienced
personnel.
It is not possible for SunModo to be aware of all the possible job site situations that could cause an unsafe
condition to exist. The installer of the roof system is responsible for reading these instructions and
determining the safest way to install the roof system. These instructions are provided only as a guide to
show a knowledgeable, trained erector the correct part placement one to another. If following any of the
installation steps would endanger a worker, the erector should stop work and decide upon a corrective
action. Provide required safety railing, netting, or safety lines for crew members working on the roof.