Pitched Roof Mount System
With Self-grounding Hardware
Pitched Roof Mount System
15
of
24
EZ Roof Mount Installation
From the marked location, move
down the roof 2-1/4
” from the
bottom of the shingle, and drill the
pilot hole for the lag bolt with a
7/32” drill bit. For maximum
strength, the hole should not be
more than 3
” in depth, and a drill
stop may be used to insure this.
Fig. 6
: Locate lag screw mounting. Drill a 7/32
” hole
through the shingle to a depth of 2 inches
Clean sawdust with drill and fill
hole with sealant. Use the 4 inch
by 5/16” lag bolt (supplied) to
install the aluminum roof shoe.
(Use Chem-link M1 Construction
Sealant or Equivalent)
Fig. 7
: After filling the hole with sealant, secure
the roof shoe with the lag bolt. Tighten to 20 ft. lbs