8. Setting the ZONE parameters
EXAMPLE: “ZONE A: 1000W”.
1
Press “OK”, enter into “HOME”.
2
Press “
t
or
u
”, select “ZONE A” or “ZONE B”.
Select “TYPE” power options: 250W, 400W,
600W or 1000W.
Select “POWER” options: Dimming 0% (OFF),
60% - 110% (ON).
R/S: Sunrise/Sunset options: Select duration time of 0 - 30 min.
Dim options: Temperature control range 32° - 104° F (0° - 40° C), power reduced 60%.
Delay: Protection delay time of 0 - 30 min.
3
Press “
t
or
u
”, move cursor to the item you want to set.
4
Press “
p
or
q
”, to increase or decrease the value.
Press “”, “Hour” value will decrease.
5
After setting, “
t
or
u
”, to “NEXT”, then press “OK” to enter into the “Time Setting”.
9. Setting the timer dimming
1
Press “NEXT”, then “OK” to enter into “ZONE A”.
NOTE: Follow this same setup for ZONE B.
2
Press “
t
or
u
”, choose “
o
”, choose time and
power percentage, press “
p
or
q
”, to “
þ
”.
3
Then press “
t
or
u
”, to choose the time and
power percentage, and press “
p
or
q
”, to increase
or decrease the time and power percentage value.
4
After all value settings are set, press “OK” to save and enter into the HOME page.
10. Setting output power
1
Press “OK”, enter into “HOME”.
2
Press “
t
or
u
”, enter into “ZONE A” or “ZONE B”.
3
Press “
t
or
u
”, the choose “Power: ”.
4
Press “
p
or
q
”, to set the output power.
5
Press “OK” to save the output power you set.
NOTE: If there is no activity for 10 seconds —while
setting up your unit, the controller will automatically
go back to the “HOME” page.
