Fig.4-1:
Insert the junction bar (D) into the decorative slot 1(C1) and decorative slot 2 (C2),
and secure with bolt (CC) and flat washer (BB).
Fig.5:
Install the plastic rings (EE) into the runner of side beam 1 (B1) and side beam 2 (B2),
12 plastic rings for each runner. There are 2 Plastic rings to be each inside corner
Fig.6:
Insert the beam junction (F) into back beam 1 (E1) and beam 2 (E2) and secure with bolt (CC),
and flat washer (BB).Install the middle beam 1 (G1) an
d middle beam 2 (G2) in the same
way with back
Beam
1 (E1) and back
Beam
2 (E2).
Fig.7:
Use bolts (FF) to install the complete side beam 1(B1) (or side beam 2(B2)) to front post 1 (A1)
and back post2 (A4)(or front post 2(A2) and back p
ost 1(A3))
Fig.8:
Install the complete decorative slot to front post with bolt (GG) and flat washer
(BB)
.
Fig.9:
Install the corner support (U) to the corner of front
post, and secure them with bolt (HH) and bolt (BB).
Fig.10:
Install the complete back beam to back post with bolt (FF).
Fig.11:
Install Connecting piece 3(S3) (or Connecting piece 4(S4)) to Edge beam 1(L1) (or Edge beam
2(L2)) with Bolt (HH) and Flat Washer (BB), then fix assembled boundary beam onto Post 1(A1)
(or Post 2(A2))
with Bolt (CC) and Flat Washer (BB)
.
Fig.12:
Using connecting piece 2(S2), bolt (CC), flat washer (BB) to secure the edge beam 1(L1)
(or edge beam 2(L2)) to back
Beam
. Use bolt (CC) and flat washer (BB) to install middle beam
mounting bracket (R) and middle beam to side beam. Install connecting piece 2 (S2) to the bolt
of edge beam 1(L1)(or edge beam 2(L2))’s card slot by using bolt (DD) and flat washer (BB),
then use a bolt (CC) and flat washer (BB) to install connecting piece (2) to middle beam
.
