Hardware Pack 3
AA
M6X15 Screw
14 PCS
BB
M6 Flat washer
16 PCS
HH
M6X60 Bolt
2 PCS
Fig.16: Insert the PC piece
(M6/M7) into the rail on the small
slanted beam (U).
Fig.17: Insert the Small cover (O1 and O2)
into the lower of the PC piece 6/7 (M6 and
M7), then secure the corner plate (Q2) to
the small slanted beam (U) through three
holes with screws (AA) and flat washers
(BB).
Fig.18: Secure the cover (T) to the
small top connector (S) with bolts
(
HH
) and flat washers (BB)
Fig.19: Insert the PC piece 3/4
(M3/M4) into the middle beam
(K1/K2) and Oblique beam (J),
then insert the rails (P1/P2) into
it. Insert the PC piece 1/2
(M1/M2) into the middle beam
(K1/K2) and Oblique beam (J).
Repeat this step to install the
right roof pieces.
Fig.20: Insert the PC piece
5 (M5) into the middle
beam 2 (K2); then insert
the middle rail (P3) into it.
Insert the PC piece (M5)
into the middle beam 2
(K2).
Fig.21: Insert the cover (N1,
N2 and N3) into the lower of
PC pieces; then secure the
center plate (Q1) to the
middle beam 2 (K2) through
three holes with screws
(AA) and flat washers (BB).
Fig.22: Secure the corner
plate (Q2) to the Oblique
beam (J) through three
holes with screws (AA) and
flat washers (BB).
