9
Replacing the Cutting Line
This electric leaf mulcher/shredder features a bladeless
mulching system that utilizes 0.1 in. x 12.6 in. (2.5 mm x
320 mm) heavy-duty trimmer line. Twenty replacement cutting
lines are included in the box. Visit snowjoe.com to purchase
additional cutting line (Model SDJ616L).
1. Replace the cutting line when a noticeable decrease in
shredding efficiency is observed. To remove the worn
cutting lines, cut the old lines and pull the remaining line
out of the spinner head.
2. When installing new cutting lines, feed each end of the
new line through the two holes in the post on top of the
spinner head (Fig. 13).
3. Check that the two ends of the line are even in length on
both sides (Fig. 14).
4. Thread the lines through each corresponding ferrule
(Fig. 15).
5. Ensure that both ends of the line are straight and are even
in length (Fig. 16).
NOTE: There is a built-in line cutter that will cut and trim
the lines slightly longer than desired.
6. Refer to the above steps to replace another cutting line
(Fig. 17).
Fig. 13
Fig. 14
Fig. 15
Fig. 16
Fig. 17
Summary of Contents for SDJ616-RM
Page 12: ...snowjoe com ...
