16
3.
Put Servo Control Board onto the upper
plate. Make sure the power port of the
board is at the rear part, and that the
four mounting holes are well aligned with
those on the plate.
4.
Insert four M3*10 screws through holes on
the Servo Control Board, 4 acrylic
washers, and into 4 M3 nuts, and tighten
them. The assembly should be like this:
5.
Plug the SunFounder Nano onto the
Servo Control Board. Pay attention to
place its USB port close to the
aforementioned power port. Align the
pins with female headers as shown
below.
6.
Insert the pin into headers.
SunFounder
