9002B Rev. A :
Parts Breakdown & Operating Manual
3
03/07/13
To reduce the risk of injury, anyone using, repairing, maintaining, or changing accessories on this tool must
read and understand these instructions before performing any of these tasks.
WARNING
SAFETY INSTRUCTIONS - DO NOT DISCARD - GIVE TO USER
(CONTINUED)
AIR SUPPLY
Never mount oil and water extractor on or near the air com pres sor.
During compression, air temperature is greatly increased. As the air cools down to room tem per a ture, moisture condenses in the air line, on
its way to the spray gun. Therefore, always mount the oil and water extractor at a point in the air supply system where the compressed air
temperature is lowest.
Drain air lines properly.
Pitch all air lines back towards the com pres sor so that con densed mois ture will flow back into the air receiver where it can be drained off.
Each low point in an air line acts as a water trap. Such points should be fitted with an easily accessible drain. See diagram above.
Length of Pipe (ft.)
Air
Flow
CFM
50
100 150 200
10
20
30
40
50
70
1/2"
3/4"
3/4"
1"
1"
1"
3/4"
3/4"
3/4"
1"
1"
1"
3/4"
3/4"
1"
1"
1"
1-1/4"
3/4"
3/4"
1"
1"
1"
1-1/4"
Oil & Water
Extractor
Drain
Oil and Water Extractor should be at least 25 ft.
from the compressor, farther if possible.
25 Feet
or More
Install drain at
each low point
Compressor Unit
Pitch pipe back
toward air receiver
Drain
Some dust created by power sanding, sawing, grinding, drilling
and other construction activities contains chemicals known to
the State of California to cause cancer and birth defects or other
reproductive harm. Some examples of these chemicals are:
- Lead from lead based paints
- Crystalline silica bricks and cement and other
masonry products
- Arsenic and chromium from chemically-treated lumber
Your risk from these exposures varies, depending on how often
you do this type of work. To reduce your exposure to these
chemicals: work in a well ventilated area, and work with approved
safety equipment, such as those dust masks that are specially
designed to filter out microscopic particles.
Handling the brass parts of this product will expose you to lead, a
chemical known to the State of California to cause birth defects
and other reproductive harm.
Wash hands after handling.
iMPortANt PrecAutioN iNforMAtioN -
reAd before usiNg tHis sPrAy guN:
sPrAy guN descriPtioN
The 9002B Rev. A is a light weight, anodized aluminum, general
purpose gravity feed spray gun designed for use in various types
of spraying applications. The 9002B Rev. A can handle water
based and solvent based spraying applications.
iMPortANt:
This spray gun may be used with most common
coating and finishing materials. It is designed for use with mildly
corrosive and non-abrasive materials. If used with other high
corrosive or abrasive materials, it must be expected that frequent
and thorough cleaning will be required and the necessity for
replacement of parts will be increased..
For maximum transfer efficiency, do not use more pressure than
is necessary to atomize the material being applied.
Connect the gun to a clean, moisture and oil free air supply using
a hose size of at least 5/16" I.D. hose. Do not use 1/4" I.D. hose.
(25' x 1/4" hose at 18 cfm has a pressure loss of 25 psi. 25' x
5/16" hose at 18 cfm has a pressure loss of 8 psi.)
