Thermal Imaging Integrated Network Camera
User Manual
Installation
Issue V1.1
（
2022-05-21
）
17
3.2
Installation Mode
The thermal imaging integrated camera can be installed on the ceiling or the wall. You
can select the appropriate installation according to your requirements. If the camera
needs to be installed on the cement wall, you need to install the expansion screws (the
mounting holes of the screws must be consistent with that of the support), and then
install the support.
NOTE
The wall where the support is mounted must be able to withstand at least three times of the
total weight of the support and the camera.
The different brackets have different installation methods, please choose the correspond
method according to the purchased product.
3.2.1
Installing A Bracket
Step 1
Remove the installation location label delivered with the camera. Stick it on the
ceiling or the wall, as shown in Figure 3-8.
NOTE
If you choose the back leading mode, pouch a leading-out hole on the ceiling or the
wall, as shown in the area highlighted in red in Figure 3-1. (This manual takes the back
leading mode as an example.)
If you choose the side leading mode, lead the multi-connector combination cable
from the side notch on the bottom of the camera.
Figure 3-1
Installation location label
Location label
Wall
