Page 23
10.6 Filtration Modes for Spas Without Circulation Pump Option
If your spa is equipped with the circulation pump option, disregard this
section and refer to page 24 for filter cycle programming details.
Standard Filtration/Heating Modes (F1 - F3)
(Heater automatically turns on during any heat call while in any
Standard mode).
F1
4 hours of filtration per day (one 2-hour cycle every 12
hours).
F2
6 hours of filtration per day (one 2-hour cycle every 8
hours).
F3
8 hours of filtration per day (one 2-hour cycle every 6
hours).
Economy Filtration/Heating Modes (F4 - F6)
(Heater can only turn on during an active filter cycle while
in any economy mode).
F4
4 hours of filtration/heating per day (one 2-hour cycle
every 12 hours).
F5
6 hours of filtration/heating per day (one 2-hour cycle
every 8 hours).
F6
8 hours of filtration/heating per day (one 2-hour cycle
every 6 hours).
Lock Modes (L1 - L2)
L1
Lock Out (disables all spa functions to permit filter
cleaning).
L2
Lock Mode (disables the jets and light buttons to prevent
unauthorized use of spa). Filtration/heating cycle will
continue to operate as programmed in this mode. The
temperature display flashes when this function is en
-
able. Example: the “F3” filtration/heating cycle was enabled prior to
choosing lock mode. The spa continues to perform the “F3” cycle
until lock mode is canceled, allowing another cycle to be selected.
Filter Cycle Setup Example
To set a time for the first filtration/heating cycle, simply turn power on to
the spa two minutes prior to the desired time. EXAMPLE: If you desire
your first filtration/heating cycle to begin at 10:00 AM turn off power to the
spa and turn it back on again at 9:58 AM.
Note: start time is approximate
and may vary slightly from day to day.
