Page 13
3. Turn On Power
Turn on power to spa at the home’s circuit breaker to start boot up
sequence (sec. 9.0, page 19). The heater and filter pump will auto
-
matically activate after several seconds. If the control panel LED
flashes water temperature and “COOL” or “ICE” this is normal, refer
to pages 30-32 for additional information.
4. Activate Jets Pumps
Turn on all jet(s) pumps to ensure proper mixing when
adding start-up chemical in step 5.
5. Add Start-Up Chemicals
Add the spa water chemicals as recommended by your authorized
Sundance dealer. See section titled “WATER QUALITY MAINTE
-
NANCE” (page 29) for general guidance.
6. Establish A Stable Sanitizer Reading
Establish a stable sanitizer reading between 3.0-4.0 ppm chlorine or
2.0-4.0 ppm bromine. To ensure healthy water conditions, always
maintain a constant sanitizer reading within the levels recommended
by the Association of Pool And Spa Professionals/USA printed on
the inside cover of this manual. If sanitizer levels cannot be sta-
bilized, perform the decontamination procedure steps 9-15 on the
following page.
Note: the “decontamination procedure” steps 9-15
should also be used after the spa has been “Winterized” (sec. 11.7,
page 28) or has been sitting without power for an extended period.
7. Set Spa To Heat
To warm spa water to a comfortable temperature, follow
these steps:
•
The LED display on the control panel displays the actual tempera-
ture of the spa water. Press either the
COOLER (-) or WARMER
(+) button once to display the “set” temperature for 5 seconds. If
you want the water to heat to a different temperature, simply press
COOLER (-) or WARMER (+) within 5 seconds. The set temperature
IMPORTANT:
Always fill your spa through the filter bucket
after draining. Failure to do so may cause air to be trapped
in either pump, preventing the pump from circulating water.
Remove the hose and replace the filter cartridge. DO NOT
OVERTIGHTEN! FINGER TIGHT ONLY!
1
2