Sundance Spas Denali 680 Series, Owner'S Manual

Page: 42 / 260

Page 36
680 EXPORT SERIES
2. Locate drain hose line attached to 2 x 4 wood slat
(Figure A) with tie wraps.
3. Cut tie wraps and pull drain hose from equipment
area (Figure B).
4. Hold drain hose above water line, then unthread
drain cap (1) from hose using a counterclockwise
rotation (Figure B). Place hose on ground making
sure to direct water away from spa. If equipped,
turn valve (2) counterclockwise to open the valve
(Figure C).
5. After spa has completely drained, reinstall
drain cap on drain valve finger tight! DO NOT
OVERTIGHTEN! If equipped turn valve (2)
clockwise to close the valve.
6. Place drain hose back inside the spa equipment
bay.
7. Reinstall synthetic cabinet and screws.
8. After refilling spa, turn on power and follow the “Spa Fill Up
Procedure” (page 18).
11.3 Pillow Care (All Models Except Denali)
Remove and clean the headrest pillows as needed with soapy water
using a cloth or soft-bristle brush. To maintain water resistance and
luster, apply a quality vinyl conditioner once a month. Always remove
the pillows when adding chemical shock treatment to the spa water. The
pillows can be returned to the spa when the sanitizer reading is stable as
recommended on the inside cover of the manual.
11.4 Cleaning The Spa Interior
To preserve the sheen of your spa’s surface, it is crucial that you avoid
using abrasive cleaners or cleaners which have adverse chemical effect
on the surface. If you are not certain as to the suitability of a particular
cleanser, consult your authorized Sundance dealer. Regardless of the
cleanser used, use extreme care to assure that no soap residue is left on
the surface. This could cause severe sudsing when the spa is refilled.
11.5 Maintaining The Cover
Using the Sundance insulating spa cover anytime the spa is not in
use will significantly reduce your operating costs, heat-up time and
maintenance requirements. To prolong the life of the cover, handle it with
care and clean it regularly. Below are the care instructions.
A.
To Clean and Condition the Vinyl Cover
1. Use a garden hose to loosen debris and dirt.
2. Using a large sponge or a soft bristle brush, use diluted or mild soap
and scrub the vinyl top. Rinse clean and do not allow soap to dry on
cover. Do not use soap on the underside of the cover.
1
2
Figure B
Drain location and ap-
pearance may vary.
Figure C