Sundance Spas Denali 680 Series, Owner'S Manual

Page: 37 / 260

Page 31
680 EXPORT SERIES
English
Français
English
Nederlands
10.5 Filtration Modes
During the filtration/heating cycle the Jets pump 1 low speed will activate.
To set a time for the first filtration/heating cycle, simply turn power on to
the spa two minutes prior to the desired time. Example: If you desire your
first filtration/heating cycle to begin at 10:00 AM turn off power to the spa
and turn it back on again at 9:58 AM. You can also press the Warmer,
Cooler and Jets Pump 1 buttons simultaneously for 2 seconds to restart
the spa.
Note: Start time is approximate and may vary slightly from day to day.
Standard Filtration/Heating Modes (F1-F3)
F1 4 hours of filtration/heating per day (one 2-hour cycle every
12 hours).
F2 6 hours of filtration/heating per day (one 2-hour cycle every
8 hours).
F3 8 hours of filtration/heating per day (one 2-hour cycle every
6 hours).
Economy Filtration/Heating Modes (F4-F6)
F4 4 hours of filtration/heating per day (one 2-hour cycle every
12 hours).
F5 6 hours of filtration/heating per day (one 2-hour cycle every
8 hours).
F6 8 hours of filtration/heating per day (one 2-hour cycle every
6 hours).
Lock Modes (L1-L3)
(When in a lock mode the display will flash between the
temperature and the Lock mode number)
L1 Lock Out (disables all spa functions to permit filter
cleaning).
Note: The spa should not be left in this lock mode for an
extended period of time. Especially in colder climate or when
freezing conditions exist.
L2 Lock Mode (disables the jets and light buttons to prevent
unauthorized use of spa). Filtration/heating cycle will continue to
operate as programmed in this mode. The temperature display
flashes when this function is enable. Example: the “F3” filtration/
heating cycle was enabled prior to choosing lock mode. The spa
continues to perform the “F3” cycle until lock mode is canceled,
allowing another cycle to be selected.