Suncast HomePlace Series, Assembly Manual

Page: 14 / 47

Step 23: Remove four 4’x85” sheets siding and layout on wall as shown.
Step 24: Start siding with over-
lap at corner with 1” overhang
at end end of wall.
Step 28: Mark and cut off
excess siding as shown.
Step 25: Siding edge should
center on wall stud as shown.
Step 27: Install next siding piece as shown, keeping groove reveal
consistent with other openings on sheet. Repeat to end of wall.
Step 29: Lift and set wall as
shown.
Step 30: Fasten wall to floor
using 16p 3” nails every 8”.
Make sure edges are flush.
Step 31: Fasten siding to floor
using 7p 2-1/4” galvanized
penny nails every 8”.
Siding should be 1-1/2”
down past top of floor.
Step 26: Fasten siding to
walls using 7p 2-1/4” galva-
nized penny nails every 8”.
page 13