SB-WM32 Series
Installation Instructions
8
2.
Align two screws in display back with upper teardrop
mounting holes in mounting plate and lower display until
screws are seated in lower area of teardrop mounting holes.
(See Figure 5)
CAUTION:
Do not let go of the television at this point. Hold
the television in place while proceeding to the next step!
Figure 5
3.
Install two removed screws through lower mounting holes in
display mounting plate and into display back. (See Figure 6)
Figure 6
4.
Tighten all hardware.
CABLE MANAGEMENT
1.
Attach all cables to display.
CAUTION:
Ensure that adequate cable slack exists for
movement of display, and that cables will not be pinched by
installation of cable management cover(s) (E) or screws (G).
2.
Carefully insert cables in cavity located in lower portion of
mount arm. (See Figure 7)
3.
Install cover (E) with two 8-32 x 3/8" Phillips screws (G).
(See Figure 7)
Figure 7
ADJUSTMENTS
PIVOT / SWING TENSION
1.
Slightly loosen or tighten the adjustment screw(s) as
necessary. (See Figure 8)
Figure 8
DISPLAY ROLL / PITCH / YAW TENSION
1.
Disconnect all wires and cable from the display.
2.
Remove two
Lower
screws securing display to Centris cup.
3.
Loosen two
Upper
screws securing display.
4.
Lift display upward and away from mount.
5.
Turn the tension adjustment screw clockwise to increase
tension, or counter-clockwise to decrease tension.
(See Figure 9)
6.
Re-install display.
Figure 9
2
2
(A, B or C)
3
x 2
2
(G) x 2 or 4
Cable Path
(typical)
(E) x 1 (SB-WM32)
3
(E) x 2 (SB-WM32D)
1
5
