Installation Instructions
SB-WM32 Series
7
5.
Insert top of wall mount (A, B or C) over lip on top of wall
plate (D). (See Figure 2)
6.
Swing wall mount down flush against wall. (See Figure 2)
Figure 2
7.
Tighten set screw in bottom of wall mount. (See Figure 3)
NOTE:
Ensure set screw engages on back side of wall plate to
properly secure wall mount.
Figure 3
DISPLAY INSTALLATION
WARNING:
Exceeding the weight capacity can result in
serious personal injury or damage to equipment! It is the
installer’s responsibility to make sure the combined weight of
all components located between the SB-WM32 Series mount
up to (and including) the display does not exceed 75 lbs (34
kg).
WARNING:
IMPROPER INSTALLATION CAN LEAD TO
EQUIPMENT FALLING CAUSING SERIOUS PERSONAL
INJURY AND DAMAGE TO EQUIPMENT! DO NOT
substitute hardware. Use only hardware supplied by
manufacturer!
WARNING:
IMPROPER INSTALLATION CAN LEAD TO
ELECTRIC SHOCK OR DAMAGE TO EQUIPMENT! Screw
length must not exceed the depth of threaded mounting insert
in display.
WARNING:
OVERTIGHTENING OF SCREWS CAN
DAMAGE PARTS AND LEAD TO SERIOUS PERSONAL
INJURY AND DAMAGE TO EQUIPMENT! DO NOT over
tighten screws when installing interface bracket.
WARNING:
IMPROPER INSTALLATION CAN LEAD TO
DISPLAY FALLING CAUSING SERIOUS PERSONAL
INJURY OR DAMAGE TO EQUIPMENT! Using screws of
improper size may damage your display! Proper screws will
easily and completely thread into display mounting holes.
Ensure that screws are not too long.
WARNING:
IMPROPER INSTALLATION CAN LEAD TO
DISPLAY FALLING CAUSING SERIOUS PERSONAL
INJURY OR DAMAGE TO EQUIPMENT! Inadequate thread
engagement in display may cause display to fall! Back out
screws ONLY as necessary to allow installation of mounting
plate!
1.
Loosen the top two mounting screws on the back of the
display to prutrude 1/8" and remove the bottom two screws.
(See Figure 4)
Figure 4
(A, B or C)
(D)
5
6
(A, B or C)
(D)
7
Set
Screw
loosen
remove
to 1/8"
