SunBriteTV 5510HD, Operator'S Manual

Page: 9 / 40

SunBriteTV Model 5510HD Operator’s Manual
Page 9
TV Installation – Rear Panel Connections
Rear View Connections
13. IR Emitter Window - The Internal Infrared (IR) Control Window allows the TV to be
controlled from a remote system using IR commands.
14. RS232 - The RS232 connection allows the TV to be controlled from a remote system
using RS232 commands.
(See Appendix A of this manual for a list of RS232 control commands
and Appendix B for a Control Cable Pinout Diagram.)
15. 12 VDC - This port is for the SunBriteTV FM Radio (Item SB-FM 461) connector only.
13
14
15
Emitter Window:
Figure 15 shows an Emitter* installed. One end of the Emitter is to be mounted in front of the IR
Emitter Window. The other end is to be connected to an appropriate control block*.
* Neither the emitter or control block are supplied by SunBriteTV. See instructions that come with
your IR Emitter and control block to determine how to make the connection.
Important note: SunBriteTV recommends using a high-output IR Emitter, such as Xantech 282M.
Figure 15
IR Emitter placed over the IR Window
Cable end that will be attached to an
external control block is routed over the
Rubber Sealing Gasket of the Internal
Connect Source. See proper Internal
Connect Source instructions on Page 9.