7
3. Mark the first top screw location on the
wall, at least 630mm from the floor or
skirting board. The base of the heater
must be at least 200mm from the floor to
ensure adequate air flow into the air inlet.
Drill the first hole using a suitable drill bit.
4. Measure and mark the second drill hole,
564mm from the first hole. Drill the hole.
5. Measure and mark the bottom screw holes,
289mm below the top two holes. Drill.
6. Position the bracket over the drill holes
and screw into position.
7. To place the heater on the bracket, insert
the lower clips first then the top, and push
firmly until it clicks into position, as
shown in figure 5.
Wall mounting your heater (continued)
Figure 5
Before attaching the wheels, remove the wall
mounting bracket from the rear of the heater
by pushing down on the top clips and pulling
towards you.
1. Position the wheel assembly over the base
of the heater, with the vertical bracket to
the rear of the unit, as shown in Figure 6.
2. Align the screw hole in the vertical bracket
(C) with the screw hole in the rear of the
heater. Place the washer on the screw,
insert the screw and fix loosely. Do not
tighten.
3. Align the screw holes on the underside of
the wheel assembly (A and B) with the
holes on the base of the heater. Insert
each screw and washer and tighten.
Once all screws are correctly positioned,
tighten the screw in position C.
4. Repeat on the other side.
Attaching the wheels
Figure 6
A
B
C
Summary of Contents for Euro Plus HE4900
Page 2: ......
