After each use
1. Move the steam on/off switch on the
handle to the off position ( ) and remove
the plug from the power outlet.
2. Once the mop has cooled completely,
empty any remaining water from the tank
by turning the mop upside down above a
sink or outdoors.
3. Store the mop using the convenient
hanging loop at the top of the handle if
desired.
Cleaning the steam chamber
Over time, minerals may build up in the
steam chamber which may impede the
production of steam. It is recommended that
the chamber be cleaned after every 12-15
uses to ensure optimum performance.
1. Ensure that the mop is unplugged from the
power outlet and completely cool before
cleaning.
2. Push the nozzle lock button down toward
the mop housing. While holding the lock
in the unlocked position, turn the steam
chamber nozzle counter-clockwise and pull
it out completely from steam chamber.
3. Insert the cleaning brush into the chamber.
4. Rotate the brush while simultaneously
pulling it in and out of the chamber. This
will dislodge any accumulated minerals.
5. Insert the steam nozzle back into the
chamber and turn clock-wise to lock back
into position.
Unblocking the steam outlet
Occasionally minerals may build up and
block the steam outlet. If this occurs, remove
the rubber tip from the metal release pin and
insert the pin into the steam outlet in the
centre of the steam chamber nozzle. This will
clear any blockage that may have formed.
Unblocking the air outlet
If the mop fails to produce steam, the air
inlet in the water tank cap may be blocked.
To unblock the hole, remove the rubber tip
from the metal release pin and insert the pin
into the hole in the centre of the water tank
cap. This will release the rubber valve inside
and allow the air to flow freely.
Care and Cleaning
����������
�����������
�����������
������
�����
������
��������������������
Figure 14
�������������
������
Figure 15
Figure 16
10
