Note:
When cleaning large areas the floor
cloth may become quite wet and/or dirty.
Move the steam on/off switch to the off
position ( ) and unplug the mop from the
power outlet. Allow the used cloth to cool
before removing to rinse, wring out and
replace. Alternatively replace with a clean,
dry cloth. Follow the instructions on this page
if using a non-elasticised cloth on the utility
head.
7. Should the mop run out of steam during
use the water tank may be empty and may
need refilling. Place the mop on the tray
provided, move the steam on/off switch
to the off position ( ) and remove the
plug from the power outlet. Refill the mop
according to the instructions on page 7.
Note:
Do not use the mop without water
in the tank as this may damage the mop.
Always refill immediately once the generator
becomes noticeably louder, as this indicates
that the water tank needs refilling.
8. Once you have finished cleaning the
desired area, move the steam on/off switch
to the off position ( ) and remove the plug
from the power outlet. Place the mop on
the tray whilst cooling.
9. Allow the mop to cool completely before
storing.
Using a non-elasticised cloth
Before removing a cloth from the utility head,
ensure that the steam on/off switch is in the
off position ( ) and the plug is disconnected
from the power outlet. Allow the mop, the
utility head and the cloth to cool before
handling.
When using a non-elasticised cloth, use the
securing clips to attach it to the utility head.
Remove the utility head from the mop before
fitting the cloth.
1. Pull each clip upwards and twist 90°.
2. Place the utility head on a clean dry cloth
and fold the edges of the cloth up over the
sides of the head.
3. Twist the clips back into position so that
the cloth is secured underneath them.
4. Follow steps 2 to 9 on page 7.
Using the other attachments
Before removing an attachment from the
mop, ensure that the steam on/off switch
is in the off position ( ) and the plug
is disconnected from the power outlet.
Allow the mop and the attachment to cool
completely before handling.
To remove an attachment, depress the button
on the end of the mop and slowly pull while
rotating the attachment until it separates
from the mop. To remove the steam jet
nozzle, simply pull firmly.
Note:
Do not turn the mop upside down to fit
attachments. Putting pressure on the handle
could damage it.
Using the utility head and upholstery cloth
To use the utility head and upholstery cloth,
follow the instructions under the section
titled "Using the Eco Mop" on page 7.
Using your Eco Mop (continued)
Non-elasticised cloth
Figure 11
8
