15
Programming
1 Cup Volume
PREPARE the 1 cup filter with coffee and
tamp.
PLACE a cup under the espresso pour spouts.
PRESS and HOLD the 1 CUP button for over
1.5 seconds.
Press the 1 CUP button again once the
desired volume of espresso has been
extracted.
The espresso machine will beep twice to
indicate the new program for the 1 CUP
operation has been set.
2 Cup Volume
PREPARE the 2 cup filter with coffee and
tamp.
PLACE 2 cups under the espresso pour
spouts.
PRESS and HOLD the 2 CUP button for over
1.5 seconds.
The LED will flash and the pour will start
immediately.
Press the 2 CUP button again once the
desired volume of espresso has been
extracted.
The espresso machine will beep twice
to indicate the new program for 2 CUP
operation has been set.
Pre-infusion Programming
There are 3 programmable pre-infusion
settings to help achieve the perfect
extraction;
Infusion;
a small amount of water is released
onto the tamped coffee, and then there is
a short infusion time before a steady flow
of water is released. Your espresso machine
comes with this selection as a factory setting.
Constant;
delivers a constant water flow from
start to finish.
Progressive;
small amounts of water are
released onto the tamped coffee prior to a
steady water flow.
1. Ensure the espresso machine is plugged in
and switched on at the power outlet.
Note:
DO NOT press the POWER button on
the espresso machine.
2. PRESS and hold down both the MANUAL
and 1 CUP buttons.
3. While still holding down the MANUAL
and 1 CUP buttons briefly PRESS and
RELEASE the POWER button and then
release both the MANUAL and 1 CUP
buttons.
To indicate you have activated the
programmability of the pre-infusion
selections, a light on one of the buttons will
illuminate;
1 CUP = Infusion (Factory setting)
2 CUP = Progressive Pre-infusion
MANUAL = Constant Pre-infusion
This light will remain on for up to 5 seconds
before automatically returning to factory
settings if no action is taken. The espresso
machine will then power on.
Advanced Programming
