3
2
FEATURES OF YOUR HAIR DRYER
Magnetic Hand
Locking System
Hi, Low
Control Switch
3-Ft. Power Cord
Hair Dryer
Removable
Lint Screen
Expandable
Power Cord
1632-040 shown here*
Wall Mount Cradle
On Button
Test and
Reset Buttons
Off Button
Off Switch
Night Light
ALCI
OPERATING INSTRUCTIONS
This dryer is equipped with an appliance leakage circuit interrupter
(ALCI) for your safety.This device is designed to make the appliance
inoperable under some abnormal conditions (such as accidental
immersion in water).
After the appliance is plugged in, you must check your protective
device as follows:
1. Press the “Reset” button on the ALCI device.
2. Press the “Test” button.The “Reset” button will pop out.This
verifies that the protective device is working properly.
3. Press the “Reset” button once more to reactivate the safety device
and use your appliance.
REPEAT THE ABOVE PROCEDURE BEFORE EACH USE TO CONFIRM THAT
THE PROTECTIVE DEVICE IS OPERATING.
If your protective device does not operate as described above, please
contact your nearest authorized Sunbeam distributor.
MOUNTING INSTRUCTIONS
For use on sheetrock or wood walls only.
The Sunbeam
®
Wall Mount hair dryer is designed for installation on
sheetrock or wood walls only.To mount onto wall, be sure there are
no hidden electrical circuits or pipes in the mounting location.
F O L L O W T H E S E I N S T R U C T I O N S
1. Remove wall bracket from the unit.
2. Use the bracket or
locking plate (optional)
as template to mark
position of holes for
drilling close to
electrical outlet, away
from tub or sink.
3. Drill three 3/16 inch
holes.
4. Insert the three anchor
bushings by tapping
lightly with a hammer
until the shoulder of
the bushing rests
against the wall.
5. Position wall bracket
and tighten the two
bottom screws first,
then tighten the top
screw. (Anchor
bushings and screws
are provided for you).
6. Match the slots on the back of the mounting base with the hooks
on the bracket.
7. Press base onto the hooks and slide down to insure secure
mounting. (If using locking plate, remove small screw from center
of magnet and replace with longer screw included).
8. Plug the unit into the nearby electrical outlet (110 volt, 50 – 60
cycle AC only).
DANGER
– To reduce risk of electrocution, do not install where unit
can fall into tub or sink.
M O U N T I N G
I N S T R U C T I O N S
BRACKET
Screw
Plug
Anchor
Bushing
WALL MOUNT
UNIT (Base)
LOCKING PLATE
(Optional)
1632-040 shown here
*1632-020 is without the night light
SHP_HairDryer1632-IB 6/10/04 11:30 AM Page 5
