Chapter 1
General Information
7
Oracle Solaris Jumpstart Example
This Oracle Solaris Jumpstart profile example shows how to use the WWID syntax
when installing the OS on a specific disk drive. The
SASDeviceName
is taken from
the previous configuration listing.
Note –
The Oracle Solaris syntax rules require all alpha characters to be capitalized.
Interactive Installation Example
In an interactive installation, you are asked to specify one or more disks as the
targets for the OS installation. The purpose of this step is to ensure that enough disk
capacity is provided for the installation. For this step, specify the disk with the
WWID value corresponding to the drive on which you want to install the software.
These WWID values are illustrated in the following interactive example,. The drive
selected as the install target is located in HDD slot 0, the default OBP location.
/pci@400/pci@1/pci@0/pci@2/LSI,sas@0
<===== SAS Controller
MPT Version 2.00, Firmware Version 4.05.52.00
Target 9
Unit 0 Disk SEAGATE ST930003SSUN300G0868 585937500 Blocks, 300 GB
SASDeviceName 5000c500231694cf SASAddress 5000c500231694cd PhyNum 0
Target a
Unit 0 Disk SEAGATE ST973402SSUN72G 0603 143374738 Blocks, 73 GB
SASDeviceName 5000c50003d37fcb SASAddress 5000c50003d37fc9 PhyNum 1
#
install_type flash_install
boot_device c0t5000C500231694CFd0 preserve
archive_location nfs
129.148.94.249:/export/install/media/solaris/builds/s10u9/flar/latest.flar
# Disk layouts
#
partitioning explicit
filesys rootdisk.s0 -----------free /
filesys rootdisk.s1 -----------8192 swap