Sun Microsystems XVR-500, Installation Manual

Page: 24 / 50

12 Sun XVR-500 Graphics Accelerator Installation Guide • September 2002
The installation program also displays similar prompts when checking for
Sun OpenGL for Solaris versions. If Sun OpenGL for Solaris is fully installed on
your system, the program checks for required patches. If no patches are found, the
program installs the appropriate patches during the installation process.
5. Select the appropriate Sun OpenGL for Solaris version.
Option
1
, Sun OpenGL 1.2.3 for Solaris, is selected for this example:
6. Press any key and Return to start installation.
Once complete, the following is displayed and the program provides a directory for
locating a file log of the installation process. The program also provides
configuration and reboot instructions.
About to take the following actions:
- Install Sun XVR-500 Graphics Accelerator support for Solaris 8
- Install Sun OpenGL 1.2.3
To cancel installation of this software, press ’q’.
Press any other key to begin installation:
*** Installing Sun XVR-500 Graphics Accelerator support for Solaris 8...
*** Installing Sun OpenGL 1.2.3...
*** Installation complete.
To remove this software, use the ’remove’ script on this CDROM, or
the following script:
/var/tmp/ifb.remove
A log of this installation can be found at:
/var/tmp/ifb.install.2002.08.06
To configure a Sun XVR-500 Graphics Accelerator, use the fbconfig
utility. See the fbconfig(1m) and SUNWifb_config(1m) manual
pages for more details.
*** IMPORTANT NOTE! ***
This system must be rebooted for the new software to take effect.
Reboot this system as soon as possible using the shutdown command and the
’boot -r’ PROM command (see the shutdown(1M) and boot(1M) manual pages
for more details).