Sun Microsystems Ultra 80 SCSI, Installation Manual

Page: 22 / 28

3-4 Sun Ultra 80 SCSI Cable Installation Guide • March 2000
FIGURE 3-2
Installing Any Optional Tape Drive Component
3.3 Replacing the Peripheral Assembly
Caution – Use proper ESD grounding techniques when handling components. Wear
an antistatic wrist strap and use an ESD-protected mat. Store ESD-sensitive
components in antistatic bags before placing them on any surface.
1. Replace the peripheral assembly as follows (
FIGURE 3-2
):
a. Position the peripheral assembly into the chassis.
b. Connect the rear cable connectors as required.
c. If an optional drive component is being installed, undress the optional drive
component power harness and route it from the CPU area into the peripheral
area.
d. Using a No. 2 Phillips screwdriver, tighten the captive screws securing the
peripheral assembly to the chassis.
2. Replace the peripheral bezel assembly.
Filler panel
Filler panel
Screw (4)
Screw (4)
CD-ROM drive
Diskette drive
Optional
component
location