Sun Microsystems Ultra 80 SCSI, Installation Manual, Page: 21 / 28

Chapter 3 Removing and Replacing the Peripheral Assembly 3-3
3.2 Installing an Optional Component
Note – Ensure that the peripheral power cable and all data cables are properly
routed through the clips adjacent to the peripheral assembly. Route the SCSI data
cable through the cable management hooks (part of chassis) adjacent to the hard
drive cage.
Caution – Use proper ESD grounding techniques when handling components. Wear
an antistatic wrist strap and use an ESD-protected mat. Store ESD-sensitive
components in antistatic bags before placing them on any surface.
1. Remove the filler panel, if necessary (
FIGURE 3-2
).
2. Position the optional component into the middle shelf of the peripheral assembly.
3. Using a No. 2 Phillips screwdriver, tighten the four screws securing the optional
component to the peripheral assembly.
4. Replace the peripheral assembly.
See Section 3.3 “Replacing the Peripheral Assembly” on page 3-4.