Sun Microsystems SunSAI/P, User Manual

Page: 33 / 60

Chapter 5 Device Driver Installation 19
Rebooting the System
If you have installed additional boards since you have installed the driver software,
perform a reconfiguration boot before using the
saipconfig
utility.
1. Shut down your system and display the OpenBoot prompt (
ok
) using the
procedures described in the Solaris Handbook for Sun Peripherals or your system
service manual.
For example, you can shut down the system using the
shutdown
command:
Refer to the
shutdown(1m)
man page for more information.
2. Perform a reconfiguration book by typing the following at the OpenBoot prompt:
Automatic Configuration
Follow this procedure to use the
saipconfig
utility to configure the SunSAI/P
interfaces on your system automatically.
1. Log onto to your system console as superuser (root).
2. To start the
saipconfig
utility, type:
3. Answer yes (
y
) to accept the default configuration.
# /usr/sbin/shutdown -y -g10 -i0
ok boot -r
# /etc/opt/SUNWconn/bin/saipconfig
The installation has detected 1 SunSAI/P serial adapter.
Would you like to automatically install the default configuration? y