Sun Microsystems SunATM 3U, Installation And User Manual

Page: 38 / 142

16 SunATM 3U CompactPCI Adapter Installation and User’s Guide • February 2001
FIGURE 3-1
Opening the Ejection Lever
5. Pull back the ejection lever and slide the card into the cPCI slot.
Caution – Do not use excessive force when installing the adapter into the cPCI slot.
You may damage the adapter’s connector. If the adapter does not seat properly
when you apply even pressure, remove the adapter and carefully reinstall it.
6. Applying even pressure at both corners of the card, push the card until it is firmly
seated in the slot.
In a full hot swap installation, when the card is properly seated and the physical
connection is complete, the blue LED lights up.
7. Push the ejection lever over the sprocket toward the card and into the locked
position.
FIGURE 3-2
Closing the Ejection Lever
This locks the card into the slot and completes the hardware installation. In a full hot
swap installation, the blue LED should go off.
If the blue LED does not go off, it either means the system into which you inserted
the card does not fully support the hot-swap feature or the card is not properly
seated.