Sun Microsystems StorEdge L1000, User Manual

Page: 92 / 128

70 Sun StorEdge L1000 User’s Guide • May 1998
Initializing Nonvolatile Information
The library nonvolatile memory resides on the robotic controller card. It retains
library configuration information (number of drives, number of bins, and so on),
calibration information, and statistics. This information should be initialized only by
an authorized field service engineer when replacing the robotic controller card.
The Service screen contains two commands involving information stored in
nonvolatile memory:
■
Initialize nonvolatile memory configuration—Returns library configuration settings to
factory-default condition, eliminating current calibration data and changes made
using the Configure Library and Configure Options.
■
Initialize nonvolatile memory statistics—Purges nonvolatile memory of all statistical
information about library operation. This information is used to generate the
statistical report described on page 65.
▼
To Execute Nonvolatile Memory Commands
1. Press the appropriate button in the Service screen.
A confirmation screen appears (
FIGURE 5-8
).
FIGURE 5-8
Confirmation Screen
2. Press Continue to execute the command.
S
Load Port
Stop
Standby
Home Back Forward
System
Off-line
Tapes Overview Operator Service Service
Report Test
Statistics
SysTest
Library
Results
Auto
Clean
SysTest
Library
Operate
Axes
Misc.
Initialize
Nonvol
Statistics
Initialize
Nonvol
Config.
Change
Password
Actuator
This will reset the library configuration. Continue?
Continue
Cancel
Cancel or Continue
Load Pack
Load Port