96053
Revision L
1-29
Powering-on the Library and Drives
■
Powering-on the Library and Drives
To power-on the library and drives:
CAUTION:
Possible equipment damage:
Make sure the power-on/off switch is set to
“O” before performing Step 1.
1. Close and lock the front door.
2. Attach the power cable to the power receptacle at the rear of the library and plug the
cable into an electrical outlet.
3. Press the power switch to the “
|
” position.
The operator status display shows the
Init in Progress:
message. When
initialization is complete, the status display shows the state of the library.
4. Use the library operator panel to configure the library and drives.
Note:
Refer to the user’s guide for any field values that you do not understand.
Note:
You must fully configure the library
before
you configure the tape
management software.
■
Recording the Configuration Information
Record your library configuration in the following table. Then make a copy of the table
and give it to the customer. The customer will refer to it when making a service call or
ordering features and upgrades.
Summary of Contents for StorageTek L40
