Sun Microsystems Netra t1 100, User And Administration Manual

Page: 140 / 154

118 Netra t1 User and Administration Guide • June 2000
▼
To Prepare the System for Installation
Note –
If you are going to install an internal CD-ROM drive (see “Installing a CD-
ROM Drive” on page 27 in Chapter 4), do so before you install the PCI card.
Otherwise you will have to remove the PCI card again.
1. Remove the Netra t1 system cover (see “Opening the Netra t1 System” on page 23
in Chapter 4).
2. Lift out the processor cover located in the rear center of the unit (see
FIGURE B-1
).
Make sure you slide the processor cover tabs from under the rear I/O card before
lifting the processor cover away from the system.
FIGURE B-1
Lifting out the Processor Cover
Tabs
SysAdmin.book Page 118 Friday, March 30, 2001 2:38 PM