Sun Microsystems Netra CP2000 Series, Parts Installation And Removal Manual

Page: 22 / 24

18 Memory Module Installation and Removal Guide • January 2003
2. Grasp the memory module with two hands (see
FIGURE 7
Segment 2).
3. Align the module connectors with the memory sockets on the Netra
CP2000/CP2100 board. Make sure the module is right side up so that the
connectors mate, and orient the midway notch on the memory module towards the
front panel of the cPCI board (see
FIGURE 7
Segment 2).
4. Seat the module firmly into position so that it fits onto the board connectors,
while pressing down on the module with your fingers (see
FIGURE 7
Segment 3).
The module connectors are fully engaged with the board connectors when you hear
or feel them snap into place.
Caution – Do not apply excessive pressure to connectors. Doing so may fracture the
connectors or the Netra circuit board.
The above procedure describes an installation of one memory module on to the
Netra CP2000/CP2100 board. If you wish to install a second memory module, follow
Step 1 to Step 4. The only difference is that you position the connectors of the second
memory module on the memory module connector sockets of the first module in a
piggy-back style, and then seat the connectors.
5. Rotate the turrets back to the position shown in
FIGURE 7
Segment 4.
!