Sun Microsystems Netra 240, Service Manual

Page: 53 / 154

Chapter 3 Removing and Replacing Front and Rear Panel Components 35
FIGURE 3-2
Disconnecting the Bezel Cables
5. Unscrew and remove the bezel screws from the bezel hinges.
6. Lift and pull the bezel forward to remove it from the server.
Installing the Bezel Assembly
1. Mount the new bezel and hinges onto the server.
2. Secure the bezel assembly to the server using the screws.
3. Reconnect the bezel cables (
FIGURE 3-2
).
4. Close the bezel assembly.
5. Power on the server.
See “Powering On the Server” on page 20 .
Bezel screws