Sun Microsystems Blade X6240, Installation Manual

Page: 39 / 72

Chapter 2 Setting Up the Server Software 27
4. Do one of the following:
■
To configure a static Ethernet configuration, type the following commands:
-> set pendingipdiscovery=static
-> set pendingipaddress=
xxx.xxx.xx.xx
-> set pendingipnetmask=
yyy.yyy.yyy.y
-> set pendingipgateway=
zzz.zzz.zz.zzz
-> set commitpending=true
where xxx.xxx.xx.xx, yyy.yyy.yyy.y and zzz.zzz.zz.zzz are the IP address,
netmask, and gateway for your ILOM and network configuration. To
determine these addresses, see your system administrator.
■
To configure a dynamic Ethernet configuration, type the following commands:
-> set pendingipdiscovery=dhcp
-> set commitpending=true
5. To log out of ILOM, type:
-> exit
If you connected to the server module ILOM through the CMM ILOM, you will
be returned to the CMM ILOM.
If you connected to ILOM using SSH, you will be disconnected automatically
because you logged in under a different IP address. If it is taking a long time to be
disconnected, you can force a disconnect by typing
~.
in the SSH window.
The following display shows a typical session where the user looks at static settings,
configures them to be dynamic, then looks at the new settings.