Sun Microsystems 5945532, User Manual

Page: 49 / 58

Chapter 6 Configuring VLANs 31
2. Plumb the Sun 10GbE XFP SR PCI Express Card interface:
where
xxx.xxx.xx.xxx
= the IP address of the interface.
3. Add the VLAN instance (VID).
For example:
where
eth6
is the interface and
5
is the VID.
Note –
In Linux systems, you can use any single digit as the VID.
4. Configure the
ixgbe
VLAN (
eth2
in this example):
where xxx.xxx.xx.xxx = the IP address of the interface.
▼
To Configure VLANs in a Microsoft Windows
2003 Environment
1. Click Control Panel.
2. Click Network Connection.
3. Click the folder icon from the sub-manual bar.
4. Right-click the Sun 10GbE XFP SR PCI Express Card port, then select
Properties.
5. Click Configure.
6. Click VLAN, then click on New.
7. Type
VLAN
with ID (for example, type
Vlan10
).
8. Click Internet Protocol (TCP/IP).
9. Click Use the following IP address.
10. Type the IP address.
# ifconfig eth6
xxx.xxx.xx.xxx
up
# vconfig add eth6 5
# ifconfig eth6.5
xxx.xxx.xx.xxx
up