Using Your Sunbed
Before using your sunbed, please note the following important pre-
cautions.
• Your skin should be free of cosmetics, tanning oils, or other body
lotions prior to tanning except for those specifically made for use
with tanning devices. However, do not remove natural body oils by
bathing or showering immediately before tanning.
• Your hair should be free of gels, mousses, sprays, or other hair prod-
ucts prior to tanning. These products can cause damage to the
sunbed acrylic. As an alternative, a shower cap or towel can be
worn to keep treated hair away from the sunbed surfaces.
• Your sunbed is designed for individual use. Always wear the safety
goggles supplied with your sunbed or another approved pair of gog-
gles, as defined under 21 CFR 1040.20. Regular sunglasses do not
provide adequate protection from ultraviolet light.
Exposure Times
Follow the guidelines for skin type and exposure times as shown in the
table on reverse. Untanned persons should not tan on consecutive days
during their first week of tanning. Never tan more than once a day.
Tanning normally appears after the first few sessions and maximizes
after approximately four weeks. Tan once or twice per week thereafter
to maintain appearance. Persons already having a base tan may begin
at advanced levels corresponding to the extent of their base tan.
Operation
(When connected to the T-Max® Manager or T-Max® 1A or 3A.)
1
If the remote system has been set to allow a pre-tanning delay time,
the timer display (A) will repeatedly flash the delay symbol “dL” and
then the remaining delay time. Press the timer button (B) or wait
until the delay time has expired to begin the tanning session. The
lamps will turn on and the timer will begin to count down. If a tan-
ning time less than the displayed time is desired repeatedly press
the timer button (B) to decrease the remaining time.
2
Lift the canopy, lie down on the bench (face up) and lower the
canopy as close to your body as possible.
3
When the timer reaches “0” the lamps turn off. If you want to stop
your session before time expires, press the stop button (C).
4
Raise the canopy by using the outer edge of the canopy, do not
push up on the acrylic shield as it may crack. The cooling fans run
for three minutes after the lamps shut off to aid in cooling the
sunbed. The timer will indicate “..” as a reminder to clean the
sunbed. After the sunbed is cleaned press the timer button and the
display will return to “0”.
26713-01A - Page 5
Operation
(When used without remote or when connected to a remote system
using a control relay)
1
Press the timer button (B) to begin the tanning session. The timer dis-
play (A) displays the remaining time. The lamps will turn on and the
timer will begin to count down from the maximum tanning session
time. If a tanning time less than the displayed time is desired repeat-
edly press the timer button (B) to decrease the remaining time.
2
Lift the canopy, lie down on the bench (face up) and lower the
canopy as close to your body as possible.
3
When the timer reaches “0” the lamps turn off. If you want to stop
your session before time expires, press the stop button (C).
4
Raise the canopy by using the outer edge of the canopy, do not
push up on the acrylic shield as it may crack. The cooling fans run
for three minutes after the lamps shut off to aid in cooling the
sunbed.
A Timer display
- Displays remaining time.
B Timer button
- Turns bed on. Timer display shows remaining time.
If a lesser time is desired, press timer button until desired time
is displayed.
C Stop button
- Interrupts tanning session.
A
B
C
