CAUTION
Failure to engage locking clips may
result in the ball joints working loose,
allowing the canopy to fall, which may
result in damage to the unit and injury.
Lift and lower canopy a few
times to lubricate gas springs
for optimum performance.
11
THREADED
LOCKING RING
RECEPTACLE
ON BENCH
CANOPY TO BENCH
POWER CORD
Connect the canopy to
bench power cord to the
bench receptacle. Align the
terminals and firmly push
on until seated then tighten
the threaded locking ring.
12
Plug the power cord into a dedicated
outlet (see
Electrical Requirements
).
14
The unit is shipped with a Remote
Control Bypass Plug installed. Your
sunbed will not operate without either
the bypass plug or a remote system
connected. If remote operation is
desired, see
Remote Connections
.
13
Place the bushings
into hinge brackets.
6
26713-01A - Page 3
Lift the canopy and hold it
between the hinge brackets.
7
Insert 5/16” x 1 1/2” bolts with
nylon washers into both hinge
brackets. Tighten bolts into the
endcap threaded inserts until snug,
then an additional half turn. Do
not overtighten to avoid damaging
threaded inserts.
8
PIVOT STUD
LOCKING
CLIP
SCREW-
DRIVER
Use a screwdriver to
pry back the locking
clips on the gas springs
as they are installed.
9
With a helper holding the canopy open,
align ends of gas spring ball joints with
pivot studs and push into place. Be sure
rod end is down as shown. DO NOT lower
canopy until both gas springs are engaged!
10
