5
Reversing the Door Swing (select units only)
Figure 1 (Default position) Figure 2 (After door reversal)
1. Upper hinge cover
6. Screws
2. Screws
7. Hole cover
3. Upper hinge
8. Cabinet
4. Door
9. Pin cap
5. Lower door hinge
Depending on your door finish, the beer dispenser can be opened from either the right side or
the left. By default, the door hinge is on the right side. If you prefer it on the left, please follow
these instructions providing your model number does not end in SSTB, SSHV, or DPL:
Note: All of the parts that are removed must be kept for the reinstallation of the door.
1.
Remove the three screws (6) holding lower door hinge (5). Keep hinge for later use.
2.
Remove the door from the upper hinge (3), and keep the padded surface upward to
prevent scratching.
3.
Remove the upper hinge cover (1), remove the two screws (2), remove the upper hinge
(3) and keep it for later use.
4.
Remove the hole cover (7) and transfer it to the same location on the opposite side.
5.
Insert the lower door hinge (5) into the left side, fixing the hinge into place by tightening
all the screws (6).
6.
Remove the pin cap (9) from the left side of the upper door frame and then transfer it to
the same location on the opposite side.
7.
Set the door on the lower door hinge (5), keep the door level, then fix the upper hinge (3)
to the body (8) by the screws (2).
8.
Put on the upper hinge cover (1).