background image

 

 

 

It is important for the appliance to be leveled in order to work properly. You may need to make 

several adjustments to level it. 

 

Although the unit has been tested at the factory, due to transit and storage, you should clean the 

appliance before use. 

 

Do not use solvent-based cleaning agents or abrasives on the interior. These cleaners may 

damage or discolor the interior. 

 

Do not use this apparatus for other than residential purposes. 

 

This appliance is CFC- and HFC-free and contains small quantities of Isobutane (R600a) which is 

environmentally friendly, but flammable. It does not damage the ozone layer, nor does it increase 

the greenhouse effect. Care must be taken during transportation and setting up of the appliance 

that no parts of the cooling system are damaged. Leaking coolant can ignite and may damage the 

eyes. 

 

In the event of any damage: 

-    Avoid open flames and anything that creates a spark, 

-    Disconnect from the electrical power line, 

-    Air the room in which the appliance is located for several minutes, and 

-    Contact the Service Department for advice. 

 

The more coolant there is in an appliance, the larger the room it should be installed in. In the 

event of a leakage, if the appliance is in a small room, there is the danger of combustible gases 

building up. For every ounce of coolant, at least 325 cubic feet of room space is required. The 

amount of coolant in the appliance is stated on the data plate on the back of the appliance. It is 

hazardous for anyone other than an authorized Service Person to carry out servicing or repairs to 

this appliance. 

 

Take serious care when handling, moving, and using the appliance to avoid either damaging the 

refrigerant tubing or increasing the risk of a leak. 

 

Replacing component parts and servicing shall be done by factory authorized service personnel 

so as to minimize the risk of possible ignition due to incorrect parts or improper service. 

 

DANGER!        Risk of child entrapment

 

Child entrapment and suffocation are not problems of the past. Junked or abandoned appliances 

are still dangerous, even if they will “just sit in the garage a few days”. 

 

Before  you  throw  away  your  old  wine  cooler  or  any  appliance:

    Remove  the  door.   

Leave the shelves in place so that children may not easily climb inside. 

 

Never allow children to operate, play with, or crawl inside the appliance. 

 

- SAVE THESE INSTRUCTIONS - 

Summary of Contents for AL55













Reviews: